After the paint has dried it is now time to balance the cells and add your feathers, tensel, or streamers to the outriggers. ![]() (I got my group of royal rangers to do this for me because this was going to be their kite.) If you do it this way make sure that the ends of both the left and the right horizontal support match up to the edges of the cell.) Next you paint or have someone else paint each of the cells to your specified color scheme. (I placed the glued my horizontal supports together before I glued them to the cell, but this can be done either way. Then glue the horizontal supports together to strengthen the supports. Next place each of the the horizontal support across the cell and glue in place at the 3 and 9 o-clock marks on the cell. Place the bottom of the vertical support on the bottom of the cell, and glue it at the 6 and 12 o-clock marks. Place the vertical support across the cell. ![]() (For my build the cells where 9 inches wide and each vertical support was 11 inches long, and the horizontal supports were 39 inches long.) To build the cells you need to mark each cell, on the concave side (the side you put food on), at 3, 6, 9, and 12 o-clock. To cut the dowel rods, take an exacto knife and score the dowel rod where you want to cut it and grip it on both side of the score line a snap it. It will take 2 dowel rods for the horizontal supports. The horizontal supports should also be the full diameter of the cell and extend 30" to each side. ![]() The vertical supports should be the full diameter of the cell and extend 2 inches at the top. First thing you need to do is cut the dowel rods for the vertical and horizontal supports. The high heat would melt through the plate. I found that using the low heat setting was easier to work with on styrofoam.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |